Siemens WM..T SERIES Manuel d'instruction et instructions d'installation - Page 29

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction et instructions d'installation pour {nom_de_la_catégorie} Siemens WM..T SERIES. Siemens WM..T SERIES 40 pages.

Imprimer la page

VoltMonitor

The automatic voltage control system
detects an unacceptable low voltage
supply. The colon on the Ready in
display is flashing while there is an
unacceptable undervoltage supply.
Once the supply voltage is stable again,
the colon of the Ready in display lights
up (Normal mode).
The detected voltage under-usage is
indicated in the further program
sequence by all three points lighting up
in the display.
Voltage under-usages can for
Note:
example result in program extensions
and/or non-satisfactory results.
M

Setting the signal

You can change the following settings:
S e t t i n g t h e s i g n a l
The volume of the information
■
signals (e.g. at the end of the
program) and/or
The volume of the button signals.
■
You will need to activate the setting
mode in order to change these settings.
Setting the signal
Activating the setting mode
Select the Cottons program at
1.
position 1. The washing machine is
switched on.
Press the ‹ button and, at the same
2.
time, turn the program selector
clockwise to position 2. Release the
button.
The setting mode is activated and the
preset volume for the information
signals appears in the display panel.
Changing the volume
To change the volume of the
■
information signals, use the Finish in-
time button, while the program
selector remains at position 2.
To change the volume of the button
■
signals, rotate the program selector
to position 3. Use again the Finish in-
time button to change the volume.
0 = off, 1 = quiet,
2 = medium, 3 = loud,
4 = very loud
Exiting setting mode
You can now end the process and set
the program selector to the off position.
The settings are saved.
en
29