Cisco 7931G - Unified IP Phone VoIP Manuel d'administration - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'administration pour {nom_de_la_catégorie} Cisco 7931G - Unified IP Phone VoIP. Cisco 7931G - Unified IP Phone VoIP 12 pages. For cisco unified callmanager express 4.0
Également pour Cisco 7931G - Unified IP Phone VoIP : Manuel de l'utilisateur (20 pages), Manuel d'administration (10 pages), Manuel d'administration (17 pages), Manuel d'administration (20 pages), Instructions d'installation (4 pages), Manuel (30 pages), Référence rapide (2 pages), Carte de référence rapide (2 pages), Manuel de l'utilisateur (15 pages)

Cisco 7931G - Unified IP Phone VoIP Manuel d'administration
Cisco Unified IP Phone Installation

Network and Access Ports

The back of the Cisco Unified IP Phone includes these ports:
• Network port: Labeled 10/100 SW
• Access port: Labeled 10/100 PC
Each port supports 10/100 Mbps half- or full-duplex connections to external devices. You can use either
Category 3 or 5 cabling for 10-Mbps connections, but you must use Category 5 for 100 connections.
Use the SW network port to connect the phone to the network. You must use a straight-through cable on this
port. The phone can also obtain inline power from a switch over this connection. For details, see
IP Phone
Use the PC access port to connect a network device, such as a computer, to the phone. You must use a
straight-through cable on this port.
Handset
The handset is designed especially for use with the Cisco Unified IP Phone 7931G. It includes a light strip
that indicates incoming calls and voice messages waiting.
To connect a handset to the Cisco Unified IP Phone, plug the cable into the handset and the Handset port on
the back of the phone.
Note
The handset does not support wideband audio.
Speakerphone
By default, the speakerphone is enabled on the Cisco Unified IP Phone.

Disable Speakerphone

To disable the speakerphone using Cisco Unified CM Administration, perform the following procedure:
Procedure
Step 1
Choose Device > Phone and locate the phone you want to modify.
Step 2
In the Phone Configuration window, check Disable Speakerphone.
Step 3
Click Apply.
Power.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
Network and Access Ports
Cisco Unified
3