Siemens SMI50E56EU Manuel d'utilisation - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Siemens SMI50E56EU. Siemens SMI50E56EU 40 pages.

Imprimer la page

Operating the appliance

Switching off the appliance

Short time after the end of the

programme:

1. Switch off ON/OFF switch (.

2. Turn off the tap (not applicable if

Aqua-Stop fitted).

3. Remove the utensils when they have

cooled down.

Note

When the programme ends, leave

the appliance to cool down a while

before opening it. This will prevent

steam from escaping and causing long-

term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.

The LEDs go out. The programme is

saved.

If the door was opened on an

appliance which has a warm water

connection or is heated, first leave

the door ajar for several minutes and

then close. Otherwise, expansion

(pressure) may cause the appliance

door to spring open or water to run

out of the appliance.

2. To continue the programme, switch

on the ON/OFF switch ( again.

T erminating the programme

T e r m i n a t i n g t h e p r o g r a m m e

(Reset)

1. Press START button @ for

approx. 3 sec.

The numerical display H

indicates :

2. The programme sequence lasts

approx. 1 min. On the digital

display H is indicated :

3. Switch off ON/OFF switch (.

Changing the programme

When the START button @ has been

pressed, the programme cannot be

changed.

The only way a programme can be

changed is by Cancel programme

(Reset).

Intensive drying

The final rinse uses a higher

temperature which improves the drying

result. The running time may increase

slightly. (Caution if utensils are delicate!)

1. Close the door.

2. Switch on ON/OFF switch (.

3. Press and hold down the START

button @.

4. Rotate programme selector 8

until :

is indicated on the digital

display H.

5. Release button.

The factory-set value :

the digital display H (intensive

drying off).

Change the setting as follows:

1. By rotating the programme selector

8, you can switch intensive drying

on :

or off :

2. Press START button @.

The set value is saved.

is lit on