Siemens ED8 FS11E Series Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Siemens ED8 FS11E Series. Siemens ED8 FS11E Series 36 pages. Induction hob with integrated ventilation system

Imprimer la page

The control panel

Touch controls
Switch the appliance on and off
#
Lock the control panel for cleaning
Ñ
Activate the childproof lock
1
Switch between the setting areas for the
I
hob and the ventilation system/reset the
saturation indicators
Select a hotplate
»
0 IIIIIIIIIIII
Apply heat settings/select fan settings 1-
9 on the left-hand setting area
b
Switch on the PowerBoost function for heat
settings/switch on intensive mode for the
ventilation system
Switch on the Combi zone function
þ
Activate the Move function
ú
Program the cooking time and kitchen
0
timer
Indicators/symbols
Operating status
â
Heat settings/fan settings
‚
-
Š
Timer function
‹‹
Residual heat
•
/
œ
PowerBoost function/intensive mode for
›
ventilation
Combi zone function
ø
Move function
ú
Programming the cooking time
x
Kitchen timer
V
Timer displays
ö
Metal grease filter saturation indicator
"‚ ‹
Activated charcoal filter saturation indicator
"‚ ‚
Getting to know your appliance
Touch controls
Touching a symbol activates the associated function.
Notes
Always keep the control panel clean and dry.
■
Moisture reduces its effectiveness.
Do not place any cookware near the indicators or
■
sensors. The electronics could overheat.

Residual heat indicator

The hob has a residual heat indicator for each hotplate.
This indicates that a hotplate is still hot. Do not touch a
hotplate while the residual heat indicator is lit up.
The following indicators are shown depending on the
amount of residual heat:
Display
: High temperature
•
■
Display
: Low temperature
œ
■
If you remove the cookware from the hotplate during
cooking, the residual heat indicator and the selected
heat setting will flash alternately.
When the hotplate is switched off, the residual heat
indicator will light up. Even after the hob has been
switched off, the residual heat indicator will stay lit for as
long as the hotplate is still warm.

Ventilation modes

This appliance can be used in air extraction or air
recirculation mode.
Exhaust air mode
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
If the exhaust air is conveyed through the external wall,
a telescopic duct should be used.
en
11