Cisco Cisco Access Registrar 4.2 Configuration des paramètres du réseau - Page 18
Parcourez en ligne ou téléchargez le pdf Configuration des paramètres du réseau pour {nom_de_la_catégorie} Cisco Cisco Access Registrar 4.2. Cisco Cisco Access Registrar 4.2 34 pages. Telepresence conference system
Également pour Cisco Cisco Access Registrar 4.2 : Manuel de l'utilisateur (44 pages), Manuel de démarrage (46 pages)
Imprimer la page
Configuring IP Settings
Note
Assigning an IP Address
Step 2
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone
4-18
You can use 0.0.0.0 for the subnet mask only if the default gateway is also
•
0.0.0.0.
Ensure the TFTP server has an IP address.
•
Ensure the default gateway IP address is on the same subnet as the host IP
•
address.
Procedures involved in configuring IP settings or TFTP options cannot be
completed when DHCP is enabled in your network.
This section covers the following topics:
Assigning an IP Address, page 4-18
•
•
Assigning a Default Router, page 4-19
Assigning a Subnet Mask, page 4-21
•
Assigning a Domain Name, page 4-22
•
Assigning DNS Servers, page 4-24
•
The IP address is the unique logical address identifying each host computer, or
node, on a TCP/IP network. An IP address is a 32-bit number expressed as four
decimal numbers from 0 to 255 separated by periods.
Before you can assign an IP address, you must disable DHCP. For instructions,
see the
"Disabling DHCP" section on page
To assign an IP address for the Cisco Unified IP Phone, follow these steps:
In the pane on the left under Change Configuration, click Network Parameters.
Chapter 4
Configuring Network Settings on the Cisco Unified IP Phone
4-15.
4-2.
OL-8617-01