Cisco 10005 ESR Manuel - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco 10005 ESR. Cisco 10005 ESR 33 pages.
Removing and Replacing Field-Replaceable Units
Step 12
Step 13
Caution
Step 14
Removing and Installing a PCMCIA Flash Memory Card
Note
Step 1
Step 2
Cisco 10005 ESR Hardware Overview and Maintenance Guide
3-28
Reconnect any interface cables to the PRE if necessary.
Install the PCMCIA card in the PRE if necessary (see the
Installing a PCMCIA Flash Memory Card" section on page
secure the PCMCIA slot cover.
If you do not screw down the cover of the PCMCIA slot on the PRE, the open
cover exposes the unit to the risk of a harmful ESD event, and might cause
electromagnetic interference (EMI) above the prescribed levels.
Refer to the Cisco 10000 Series ESR Software Configuration Guide for
information about configuring the PRE if necessary.
It is not necessary to configure the PRE if this is a second PRE installation
Note
for redundancy. The system automatically downloads the necessary
configuration information from the primary PRE.
To remove and install a PCMCIA flash memory card:
For information about formatting flash memory cards and disks, see the
"Formatting Flash Memory Cards and Disks" section on page
Attach an antistatic wrist strap to your wrist and to the ESD socket on the chassis,
or to a bare metal surface on the chassis or frame.
Loosen the captive screw on the PCMCIA flash card cover on the PRE
(Figure
3-17).
Chapter 3
Maintaining the Cisco 10005 ESR
"Removing and
3-28). Be sure to
3-4.
OL-1102-07