Cisco 10005 ESR Podręcznik - Strona 28

Przeglądaj online lub pobierz pdf Podręcznik dla Router sieciowy Cisco 10005 ESR. Cisco 10005 ESR 33 stron.

Removing and Replacing Field-Replaceable Units

Step 12

Step 13

Caution

Step 14

Removing and Installing a PCMCIA Flash Memory Card

Note

Step 1

Step 2

Cisco 10005 ESR Hardware Overview and Maintenance Guide

3-28

Reconnect any interface cables to the PRE if necessary.

Install the PCMCIA card in the PRE if necessary (see the

Installing a PCMCIA Flash Memory Card" section on page

secure the PCMCIA slot cover.

If you do not screw down the cover of the PCMCIA slot on the PRE, the open

cover exposes the unit to the risk of a harmful ESD event, and might cause

electromagnetic interference (EMI) above the prescribed levels.

Refer to the Cisco 10000 Series ESR Software Configuration Guide for

information about configuring the PRE if necessary.

It is not necessary to configure the PRE if this is a second PRE installation

Note

for redundancy. The system automatically downloads the necessary

configuration information from the primary PRE.

To remove and install a PCMCIA flash memory card:

For information about formatting flash memory cards and disks, see the

"Formatting Flash Memory Cards and Disks" section on page

Attach an antistatic wrist strap to your wrist and to the ESD socket on the chassis,

or to a bare metal surface on the chassis or frame.

Loosen the captive screw on the PCMCIA flash card cover on the PRE

(Figure

3-17).

Chapter 3

Maintaining the Cisco 10005 ESR

"Removing and

3-28). Be sure to

3-4.

OL-1102-07