Cisco 1700 series Configuration - Page 10

Parcourez en ligne ou téléchargez le pdf Configuration pour {nom_de_la_catégorie} Cisco 1700 series. Cisco 1700 series 34 pages. Secure firewall management center
Également pour Cisco 1700 series : Manuel de conformité réglementaire et d'information sur la sécurité (45 pages), Manuel (15 pages), Manuel de configuration (25 pages), Note d'application (41 pages), Dépannage du matériel (12 pages), Manuel de synthèse (13 pages), Manuel (5 pages), Manuel de démarrage rapide (6 pages), Manuel d'installation du matériel (46 pages)

Imprimer la page

Configuring the ADSL Interface

Router (config-if) dsl operating-mode mode

This command is for testing or lab environments only. Using a mode other auto for the DSL operating

Caution

mode can lead to unpredictable behavior on the ADSL line.

Configure routing protocols on the interface. (You must have previously enabled these protocols as part

Step 8

of global configuration.) In this example, IP, AppleTalk, and IPX are being configured on the ADSL

interface:

Router(config-if)# ip address 1.10.16.16 255.255.0.0

Router(config-if)# appletalk static cable-range 5-5

Router(config-if)# appletalk zone ZZ

Router(config-if)# ipx network B004

Step 9

Configure a PVC on the interface. (You must have the VPI/VCI number from the service provider

before you configure this.)

Router (config-if)# pvc 0/33

Router (config-if-atm-vc)# protocol ip

Router (config-if-atm-vc)# vbr-rt 160 160 1

Router (config-if-atm-vc)# encapsulation aal5snap

To configure another interface, enter the exit command to return to the

Step 10

Repeat Step 6 through Step 9 of this procedure to configure the next interface.

When you finish configuring interfaces, exit configuration mode. Return to the enable prompt by

Step 11

pressing Ctrl-Z. To see the current operating configuration, including any changes you just made, enter

the show running-config command:

Router# show running-config

To see the configuration currently stored in NVRAM, enter the show startup-config command:

Router# show startup-config

The results of the show running-config and show startup-config commands differ if you have made

Step 12

changes to the configuration but have not yet written them to NVRAM. To write your changes to

NVRAM and make them permanent, enter the copy running-config startup-config command:

Router# copy running-config startup-config

Building configuration. . .

[OK]

Router#

The router is now configured to boot in the new configuration.

AutoInstall

The AutoInstall process is designed to configure the router automatically after it connects to your WAN.

For AutoInstall to work properly, a TCP/IP host on your network must be configured to provide the

configuration files. The TCP/IP host can reside anywhere on the network if the following two conditions

are met:

•

Configuring an ADSL WAN Interface Card on Cisco 1700 Series Routers

The host must be on the remote side of the router's synchronous serial connection to the WAN.

User Datagram Protocol (UDP) broadcasts to and from the router and the TCP/IP host must be

enabled.

1.10.16.16 broadcast

Router(config)#

prompt.

OL-3317-03