Cisco 1700 series Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 1700 series. Cisco 1700 series 6 pages. Secure firewall management center
Également pour Cisco 1700 series : Manuel de conformité réglementaire et d'information sur la sécurité (45 pages), Manuel (15 pages), Manuel de configuration (25 pages), Note d'application (41 pages), Dépannage du matériel (12 pages), Manuel de synthèse (13 pages), Configuration (34 pages), Manuel (5 pages), Manuel d'installation du matériel (46 pages)

Cisco 1700 series Manuel de démarrage rapide
Configuring a Leased Line
The configuration in this chapter describes how to configure a Cisco 1700 router for IP and IPX over
a synchronous serial line.
Before You Begin
The configuration in this chapter is based on the following assumptions:
Your Cisco 1700 router hardware is correctly installed according to the Cisco 1700 Router
Hardware Installation Guide that came with the router.
Your Cisco 1700 router is using multilink Point-to-Point Protocol (PPP).
Your Cisco 1700 router is using dynamic IP and IPX routing, in which IP Routing Information
Protocol (RIP) resolves IP routes, and IPX RIP and IPX SAP dynamically resolve IPX routes and
services.
Before you begin configuration, be aware of the following:
You need to enter the commands in the order shown in the task tables.
The values shown in italic are examples. You should substitute the values shown with values that
are appropriate for your network.
You should be familiar with Cisco IOS software and its conventions.
Note
commands and command modes. When you use the verification steps, you need to change to
different command modes. If you are not familiar with command modes, refer to the "Understanding
Command Modes" section in the "Cisco IOS Basic Skills" chapter.
These are the major tasks when configuring the router:
Configuring Global Parameters
Configuring Security
Configuring the Fast Ethernet Interface
Configuring the Serial Interface
Configuring Dynamic Routing Parameters
Configuring Command-Line Access to the Router
To use the verification steps described in this chapter, you must be familiar with Cisco IOS
C H A P T E R
4
Configuring a Leased Line 4-1