Cisco 1700 series 빠른 시작 매뉴얼

{카테고리_이름} Cisco 1700 series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 1700 series 6 페이지. Secure firewall management center
Cisco 1700 series에 대해서도 마찬가지입니다: 규정 준수 및 안전 정보 매뉴얼 (45 페이지), 매뉴얼 (15 페이지), 구성 매뉴얼 (25 페이지), 애플리케이션 노트 (41 페이지), 하드웨어 문제 해결 (12 페이지), 개요 매뉴얼 (13 페이지), 구성 (34 페이지), 매뉴얼 (5 페이지), 하드웨어 설치 매뉴얼 (46 페이지)

Configuring a Leased Line

The conﬁguration in this chapter describes how to conﬁgure a Cisco 1700 router for IP and IPX over

a synchronous serial line.

Before You Begin

The conﬁguration in this chapter is based on the following assumptions:

•

Your Cisco 1700 router hardware is correctly installed according to the Cisco 1700 Router

Hardware Installation Guide that came with the router.

•

Your Cisco 1700 router is using multilink Point-to-Point Protocol (PPP).

•

Your Cisco 1700 router is using dynamic IP and IPX routing, in which IP Routing Information

Protocol (RIP) resolves IP routes, and IPX RIP and IPX SAP dynamically resolve IPX routes and

services.

Before you begin conﬁguration, be aware of the following:

•

You need to enter the commands in the order shown in the task tables.

•

The values shown in italic are examples. You should substitute the values shown with values that

are appropriate for your network.

•

You should be familiar with Cisco IOS software and its conventions.

Note

commands and command modes. When you use the veriﬁcation steps, you need to change to

different command modes. If you are not familiar with command modes, refer to the "Understanding

Command Modes" section in the "Cisco IOS Basic Skills" chapter.

These are the major tasks when conﬁguring the router:

•

Conﬁguring Global Parameters

•

Conﬁguring Security

•

Conﬁguring the Fast Ethernet Interface

•

Conﬁguring the Serial Interface

•

Conﬁguring Dynamic Routing Parameters

•

Conﬁguring Command-Line Access to the Router

To use the veriﬁcation steps described in this chapter, you must be familiar with Cisco IOS

C H A P T E R

Configuring a Leased Line 4-1