Cisco 2500 Series Manuel de configuration - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco 2500 Series. Cisco 2500 Series 19 pages. Wireless controller
Également pour Cisco 2500 Series : Manuel d'installation (12 pages), Manuel de déploiement (23 pages), Manuel de configuration (50 pages), Manuel de démarrage (47 pages)
Imprimer la page
Interface
Ethernet0
Serial0
Serial1
Choose what protocols to support on your Ethernet or Token Ring interface. For
Step 4
IP-only installations, you can accept the default values for most of the questions.
A typical configuration using IP, IPX, and AppleTalk follows:
Configuring global parameters:
Enter host name [Router]: router
Enter the enable secret password, the enable password, and the virtual terminal
Step 5
password:
The enable secret is a one-way cryptographic secret used
instead of the enable password when it exists.
Enter enable secret : shovel
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password : trowel
Enter virtual terminal password: pail
Enter yes or no to accept or refuse SNMP management:
Configure SNMP Network Management? [no]:
The Simple Network Management Protocol (SNMP) is the most widely supported
open standard for network management. It provides a means to access and set
configuration and run-time parameters of routers and communication servers.
SNMP defines a set of functions that can be used to monitor and control network
elements.
Step 6
Determine if you will be using DECnet on your access server. If you are
configuring for DECnet, enter the appropriate values for your area number, node
number, and area routing:
Configure DECnet? [no]:
IP-Address
OK?
unassigned
NO
unassigned
NO
unassigned
NO
Configuring the Cisco 2500 Series Access Server 4-11
Configuring the Access Server
Method
Status
not set
up
not set
down
not set
down
Protocol
down
down
down