Cisco 2500 Series Manuel de configuration - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco 2500 Series. Cisco 2500 Series 19 pages. Wireless controller
Également pour Cisco 2500 Series : Manuel d'installation (12 pages), Manuel de déploiement (23 pages), Manuel de configuration (50 pages), Manuel de démarrage (47 pages)

Once the access server has determined that AutoInstall is not configured, it will default to

the setup facility. If the serial (WAN) cable is not connected, the access server will boot

from Flash memory and go into the setup facility.

Note

the command setup.

Configuring the Global Parameters

When you first start the setup program you must configure the global parameters. The

global parameters are used for controlling system-wide settings. Use the following

procedure to enter the global parameters:

Step 1

Step 2

You can run the setup facility any time you are at the enable prompt (#) by entering

Connect a console terminal by following the instructions in the section

"Connecting the Console Terminal and Modem" in the chapter "Installing the

Cisco 2500 Series Access Server" and then boot the access server to the EXEC

prompt (Router>).

When you have booted from Flash memory, the following information will appear

after about 30 seconds. When you see this information displayed, you have

successfully booted your access server:

System Bootstrap, Version 4.14(8), SOFTWARE

2500 processor with 16384 Kbytes of main memory

Loading igs-c-l.110-0.7 at 0x3000040, size = 3865444 bytes [OK]

F3: 3779532+85880+173868 at 0x3000060

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

Rights clause at FAR sec. 52.227-19 and subparagraph

Software clause at DFARS sec. 252.227-7013.

Configuring the Access Server

Configuring the Cisco 2500 Series Access Server 4-9