Cisco 2525 Manuel de configuration - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco 2525. Cisco 2525 23 pages. Troubleshooting guide
Également pour Cisco 2525 : Manuel de configuration (23 pages), Vue d'ensemble (10 pages), Préparation de l'installation (19 pages), Manuel de dépannage (4 pages)

Step 3

Step 4

Step 5

Step 6

Step 7

Configuring DDS

The 4-wire 56/64-kbps DSU/CSU WAN module is configured for DDS (which are leased

or dedicated lines) as the factory default, but it can be configured for either

switched 56/64-kbps service or DDS. The DDS configuration is described in this section.

To configure the 4-wire 56/64-kbps DSU/CSU WAN module for circuit-switched service,

follow the instructions in the previous section, "Configuring Switched 56."

For Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Command

Reference for more information about the commands in this section. For Cisco IOS

Release 11.1 and later releases, refer to the Configuration Fundamentals Command

Reference.

Assign an IP address to the serial port on the module:

Router(config)# interface serial port_number

Router(config-if)# ip address ipaddress subnetmask

Router(config-if)# no keepalive

If you have a 2-wire switched 56-kbps WAN module, skip this step and proceed

to Step 5. If you have a 4-wire 56/64-kbps DSU/CSU WAN module, set the

network type to switched as follows:

Router(config-if)# service-module 56k network-type switched

Set the carrier type, where carrier can be att, sprint, or other:

Router(config-if)# service-module 56k switched-carrier carrier

Enter the dialer information:

Router(config-if)# dialer in-band

Router(config-if)# dialer string targetrouter_phonenumber

Router(config-if)# dialer-group groupnumber

Router(config-if)# exit

Router(config)# dialer-list groupnumber protocol protocol permit

Router(config)#

Return to user EXEC mode:

Router(config)# exit

Router# exit

Router>

Configuring the Cisco 2524 and Cisco 2525 Routers 4-17

Configuring the Router