Cisco 2525 Préparation de l'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Préparation de l'installation pour {nom_de_la_catégorie} Cisco 2525. Cisco 2525 19 pages. Troubleshooting guide
Également pour Cisco 2525 : Manuel de configuration (23 pages), Manuel de configuration (23 pages), Vue d'ensemble (10 pages), Manuel de dépannage (4 pages)

Table 2-4

Specification

Resistance (at 96 kHz)

Capacitance (at 1 kHz)

Impedance (96 kHz)

Wire diameter

Distance limitation

1. nF = nanoFarad.

Synchronous Serial Connections

The serial port on the five-in-one synchronous serial WAN module is a 60-pin, D-type

connector. The synchronous serial port (except the EIA-530) can be configured as DTE or

DCE, depending on the attached cable. All DTE serial ports require external clocking from

a DSU/CSU or other DCE device.

You must use a special serial cable to connect the router to a modem or DSU/CSU. This

cable is available from Cisco and is usually ordered with the system. The cable uses a

DB-60 connector on the chassis end. See the appendix "Cabling Specifications for the

Cisco 2524 and Cisco 2525 Routers" for cable pinouts. For ordering information, contact a

customer service representative.

Note

manufacture your own serial cables is not recommended.

As with all signaling systems, EIA/TIA-232 signals can travel a limited distance at any

given bit rate; generally, the slower the data rate, the greater the distance. Table 2-5 shows

the standard relationship between baud rate and maximum distance.

ISDN BRI Cable Specifications

High-Capacitance Cable

160 ohms/km

120 nF

75 ohms

0.024" (0.6 mm)

32.8' (10 m)

Because of the small size of the pins on the DB-60 serial connector, attempting to

Preparing to Install the Cisco 2524 and Cisco 2525 Routers 2-13

Preparing to Connect to a Network

/km

Low-Capacitance Cable

160 ohms/km

30 nF/km

150 ohms

0.024" (0.6 mm)

32.8' (10 m)