Cab Technology PCU Series Manuel de l'opérateur - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cab Technology PCU Series. Cab Technology PCU Series 20 pages. Perforation cutter

Imprimer la page

Maintenance

6.2 Changing the Blades

Warning!

 Disconnect the printer from the electrical outlet.

1. Remove the cutter from the printer.

2. Remove the upper cover sheet  chapter 6.1.

3. Turn the axle (3) of the circular blade (2) with a screwdriver for slotted

head screws (slot width 7 mm) so that the inscription (1) of the blade

points downward. In this position the set screw (4) on the gear wheel can

be achieved from the rear of the cutter.

4. Loosen the set screw (4) a few turns.

 Notice!

Save the washers (A, B, C) for the circular blade (2) and the lineal

blade (12) when dismounting the cutter.

Attention!

The springs (6, 13) are tense.

 Always hold tight lineal blade (11) in its position and push its

axle slightly to the mounting plate (9) of the cutter.

4. Loosen the screws (8) and remove the bearing plate (15). The spring (13)

becomes slack.

5. Remove spring (13) from the lineal blade.

6. Pull the circular blade (2) out of the bearing (5). The spring (6) at the lineal

blade becomes slack.

If the lineal blade should not be changed skip to step 13.