Cab Technology PCU Series Manuel de l'opérateur - Page 17
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Cab Technology PCU Series. Cab Technology PCU Series 20 pages. Perforation cutter
Imprimer la page6
Maintenance
8. Remove the support incl. the lower cover sheet chapter 6.1.
9. Remove spring (6) and lineal blade (11).
10. Insert the axle of the (new) lineal blade withe the washer (B) in the bearing
(10) of the mounting plate.
11. Hang in the slack spring (6) to the pins of the mounting plate (9) and the
lineal blade (11).
12. Re-mount the support incl. the lower cover sheet. chapter 6.1.
13. Turn the lineal blade (11) backwards. The spring (6) gets tense.
14. Insert the Axle of the (new) circular blade (2) with the washer (A) in the
bearing (5) of the mounting plate.
15. Place the washer (C) on the axle of the lineal blade.
16. Hang in the slack spring (13) to the pins (12,14) of the lineal blade and the
bearing plate.
17. Push the bearing plate (15) onto the blade axles (2, 11). The spring (13)
gets tense.
18. Append the bearing plate (15) to the profile (7) using the screws (8).
19. Tighten the set screw (4) at the gear wheel.
20. Turn the circular blade (2) in such a position that the edges of the circular
and lineal blade touch each other.
21. Tighten the screws (8) and check that circular and lineal blade touch each
other. If necessary loosen and tighten the screws (8) again.
22. Lubricate the circular blade chapter 6.1 and adjust its initial state
chapter 6.3.
23. Re-mount the upper cover sheet chapter 6.1.
5 6
7
9 10
11
2
A
B
11
2
12
13 14 15
C
17
8