Epson 1000 ICS Commencer ici

Parcourez en ligne ou téléchargez le pdf Commencer ici pour {nom_de_la_catégorie} Epson 1000 ICS. Epson 1000 ICS 2 pages. Technical brief (scanners)
Également pour Epson 1000 ICS : Installation du logiciel (1 pages), Spécifications (2 pages), Manuel (11 pages)

Imprimer la page

Start

Here

Unpack Your

EPSON 1000 ICS

Make sure you have all the parts shown here. If any parts are missing,

contact EPSON as described in your Basics book.

You'll also need a USB cable (not included) to connect

the EPSON 1000 ICS to your computer.

Remove any tape and packing materials, as shown.

Do not remove

sticker from USB

port.

Note: There may be additional packing materials or tape in locations

different from the ones shown in these illustrations. Do not remove

the sticker covering the USB port.

Release the

Transportation Lock

Press the release button on the right side, then lift up the scanner, as shown.

Peel off the tape and remove the plastic piece from the front of the ink cartridge holders.

Remove the packing tape from the transportation lock.

Slide the transportation lock to the left.

Carefully lower the scanner back down into place.

Attach the

Paper Support

Insert the paper support into its three slots.

Plug In Your

EPSON 1000 ICS

Plug the EPSON 1000 ICS into a grounded electrical outlet.

Do not connect the USB cable yet.

Install the

Ink Cartridges

Press the

Operate button. The

Operate light comes on and the

scanner carriage and print head move.

Operate button

Press the release button on the right side, then lift up the scanner.

Unwrap the ink cartridges and remove the yellow tape.

Warning: Keep ink cartridges out of the

reach of children. If ink gets on your skin,

wash the area thoroughly with soap and

water. If ink gets in your eyes, flush them

immediately with water.

Lift up the ink cartridge

clamps.

Insert the ink cartridges with

the labels face-up.

Press down the ink cartridge

clamps until they snap shut.

Carefully lower the scanner back down into place.

Press the

Copy button to begin charging the ink delivery system.

Charging takes about two minutes.

The

Operate light flashes and

the EPSON 1000 ICS makes various

sounds. Don't turn it off while the

Operate light is flashing or you'll

waste ink.

Caution: Don't open the clamps to remove a cartridge except to replace it with a

new one. Once you remove a cartridge, you can't reuse it, even if it contains ink.

You must install both cartridges and leave them installed for all types of printing.

To avoid damaging the EPSON 1000 ICS, never move the print head by hand.

Turn over