Epson 1000 ICS Buradan başlayın

Hepsi Bir Arada Yazıcı Epson 1000 ICS için çevrimiçi göz atın veya pdf Buradan başlayın indirin. Epson 1000 ICS 2 sayfaları. Technical brief (scanners)
Ayrıca Epson 1000 ICS için: Yazılım Kurulumu (1 sayfalar), Teknik Özellikler (2 sayfalar), Manuel (11 sayfalar)

Epson 1000 ICS Buradan başlayın
Start
Start
Here
Here
1
1
Unpack Your
Unpack Your
EPSON 1000 ICS
EPSON 1000 ICS
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON as described in your Basics book.
You'll also need a USB cable (not included) to connect
the EPSON 1000 ICS to your computer.
2
Remove any tape and packing materials, as shown.
Do not remove
sticker from USB
port.
Note: There may be additional packing materials or tape in locations
different from the ones shown in these illustrations. Do not remove
the sticker covering the USB port.
2
2
Release the
Release the
Transportation Lock
Transportation Lock
1
Press the release button on the right side, then lift up the scanner, as shown.
2
Peel off the tape and remove the plastic piece from the front of the ink cartridge holders.
Remove the packing tape from the transportation lock.
3
Slide the transportation lock to the left.
4
Carefully lower the scanner back down into place.
3
3
Attach the
Attach the
Paper Support
Paper Support
Insert the paper support into its three slots.
4
4
Plug In Your
Plug In Your
EPSON 1000 ICS
EPSON 1000 ICS
Plug the EPSON 1000 ICS into a grounded electrical outlet.
Do not connect the USB cable yet.
5
5
Install the
Install the
Ink Cartridges
Ink Cartridges
1
Press the
Operate button. The
Operate light comes on and the
scanner carriage and print head move.
Operate button
2
Press the release button on the right side, then lift up the scanner.
3
Unwrap the ink cartridges and remove the yellow tape.
Warning: Keep ink cartridges out of the
reach of children. If ink gets on your skin,
wash the area thoroughly with soap and
water. If ink gets in your eyes, flush them
immediately with water.
4
Lift up the ink cartridge
clamps.
5
Insert the ink cartridges with
the labels face-up.
6
Press down the ink cartridge
clamps until they snap shut.
7
Carefully lower the scanner back down into place.
8
Press the
Copy button to begin charging the ink delivery system.
Charging takes about two minutes.
The
Operate light flashes and
the EPSON 1000 ICS makes various
sounds. Don't turn it off while the
Operate light is flashing or you'll
waste ink.
Caution: Don't open the clamps to remove a cartridge except to replace it with a
new one. Once you remove a cartridge, you can't reuse it, even if it contains ink.
You must install both cartridges and leave them installed for all types of printing.
To avoid damaging the EPSON 1000 ICS, never move the print head by hand.
Turn over