Cisco WAP321 Manuel de démarrage rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco WAP321. Cisco WAP321 13 pages. Reboot and reset to factory default settings
Également pour Cisco WAP321 : Révision (6 pages), Fiche technique (8 pages), Manuel de démarrage rapide (13 pages), Brochure & Specs (4 pages), Manuel (4 pages), Manuel (4 pages)

Imprimer la page

Cisco WAP121 and WAP321 Wireless-N

Access Points Features

Front Panel

The front panel of the devices consists of three lights: Power, WLAN, and

LAN. For full descriptions of the colors of the lights and their indications,

see

"Verifying the Hardware

under the lights.

Back Panel

The back panel of the devices consists of:

• Power Button—Use this button to turn the power on and off. It is not

applicable when using PoE.

• Power Jack—Use this jack if you are not using PoE.

• Kensington Lock Slot—Use to attach a cable and lock to the device.

• Reset—See

Factory Default Settings"

• RJ-45 Ethernet Port—Use this auto-sensing, Gigabit Ethernet (802.3)

port to connect to network devices, such as computers, routers, or

switches. Cisco strongly recommends using Cat5e or better cable

for Gigabit connectivity. You may use the Ethernet port to power your

device using PoE.

Default Settings

Parameter

Username

Password

LAN IP Address

Fallback LAN IP

Subnetwork Mask

If you are using a Cisco RV Series router, the default range for the DHCP

assigned address is from 192.168.1.100 to 192.168.1.254. Any device

connecting to the same LAN will be assigned an IP address in this range.

Cisco WAP121 and WAP321 Wireless-N Access Points

Installation". A Kensington lock slot is found

"Rebooting the Devices or Returning them to their

for information on the Reset button.

Default Value

cisco

DHCP address assigned

by server

192.168.1.245

255.255.255.0