Cisco WAP321 Skrócona instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco WAP321. Cisco WAP321 13 stron. Reboot and reset to factory default settings
Również dla Cisco WAP321: Recenzja (6 strony), Arkusz danych (8 strony), Skrócona instrukcja obsługi (13 strony), Broszura i specyfikacje (4 strony), Podręcznik (4 strony), Podręcznik (4 strony)
Drukuj stronę
Cisco WAP121 and WAP321 Wireless-N
2
Access Points Features
Front Panel
The front panel of the devices consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
"Verifying the Hardware
under the lights.
Back Panel
The back panel of the devices consists of:
• Power Button—Use this button to turn the power on and off. It is not
applicable when using PoE.
• Power Jack—Use this jack if you are not using PoE.
• Kensington Lock Slot—Use to attach a cable and lock to the device.
• Reset—See
Factory Default Settings"
• RJ-45 Ethernet Port—Use this auto-sensing, Gigabit Ethernet (802.3)
port to connect to network devices, such as computers, routers, or
switches. Cisco strongly recommends using Cat5e or better cable
for Gigabit connectivity. You may use the Ethernet port to power your
device using PoE.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco WAP121 and WAP321 Wireless-N Access Points
Installation". A Kensington lock slot is found
"Rebooting the Devices or Returning them to their
for information on the Reset button.
Default Value
cisco
cisco
DHCP address assigned
by server
192.168.1.245
255.255.255.0
3