Cisco Codec C Series Manuel de démarrage - Page 27
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Codec C Series. Cisco Codec C Series 41 pages. Telepresence conference system
Également pour Cisco Codec C Series : Manuel de l'utilisateur (44 pages), Manuel de démarrage (35 pages), Manuel de démarrage (32 pages), Manuel de démarrage (42 pages), Manuel de démarrage (46 pages)
Imprimer la page
Cisco TelePresence Video Systems
Contents
Setting the date, time and location
(When not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among other
things this information is used to time stamp messages transmit-
ted to gatekeepers and other network elements.
If you operate your system using the Touch controller, the time
is shown in the top right corner of the Touch controller display;
if you operate your system using a remote control, the time
and date is shown in the top right corner of the main display.
If you are changing a value setting,
you have to always click
save
to confirm the change.
Back to task overview
D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.
Introduction
User interfaces
1. Go to the
Configuration
Open the
2. Select your preferred date format in the
down list.
3. Select your preferred time format in the
down list.
4. Select your time zone in the
5. Open the
6. Under the
Mode
drop down list.*
a. If you select
the
Address
b. If you select Off, you have to enter the time and date
manually using either the Touch controller
Settings > Administrator Settings > Date, Time &
Location) or the remote control and on-screen menu
(Home > Settings > Date and
* NTP mode:
Auto: The time is regularly updated using an NTP server. The NTP server
address is automatically obtained from the network (DHCP).
Manual: The time is regularly updated using an NTP server. You must
manually enter the NTP server address.
Off: You must set the time manually. The time is not updated automatically.
Confirguration
Configuration
tab and select
System
Configuration.
Time
settings from the left column.
DateFormat
TimeFormat
Zone
drop down list.
NetworkServices
settings from the left column
NTP
section select Auto,
Manual
or
Off
Manual,
enter the NTP server address in
input field.
(More >
Time).
27
Appendices
drop
drop
in the
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts