Cisco Codec C Series 시작하기 매뉴얼 - 페이지 27

{카테고리_이름} Cisco Codec C Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Codec C Series 41 페이지. Telepresence conference system
Cisco Codec C Series에 대해서도 마찬가지입니다: 사용자 설명서 (44 페이지), 시작하기 매뉴얼 (35 페이지), 시작하기 매뉴얼 (32 페이지), 시작하기 매뉴얼 (42 페이지), 시작하기 매뉴얼 (46 페이지)

페이지 인쇄

Cisco TelePresence Video Systems

Contents

Setting the date, time and location

(When not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among other

things this information is used to time stamp messages transmit-

ted to gatekeepers and other network elements.

If you operate your system using the Touch controller, the time

is shown in the top right corner of the Touch controller display;

if you operate your system using a remote control, the time

and date is shown in the top right corner of the main display.

If you are changing a value setting,

you have to always click

save

to confirm the change.

Back to task overview

D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.

Introduction

User interfaces

1. Go to the

Configuration

Open the

2. Select your preferred date format in the

down list.

3. Select your preferred time format in the

down list.

4. Select your time zone in the

5. Open the

6. Under the

Mode

drop down list.*

a. If you select

the

Address

b. If you select Off, you have to enter the time and date

manually using either the Touch controller

Settings > Administrator Settings > Date, Time &

Location) or the remote control and on-screen menu

(Home > Settings > Date and

* NTP mode:

Auto: The time is regularly updated using an NTP server. The NTP server

address is automatically obtained from the network (DHCP).

Manual: The time is regularly updated using an NTP server. You must

manually enter the NTP server address.

Off: You must set the time manually. The time is not updated automatically.

Confirguration

Configuration

tab and select

System

Configuration.

Time

settings from the left column.

DateFormat

TimeFormat

Zone

drop down list.

NetworkServices

settings from the left column

NTP

section select Auto,

Manual

Off

Manual,

enter the NTP server address in

input field.

(More >

Time).

Appendices

drop

in the

Getting Started Guide

Contacts