Cisco EX90 Manuel de l'utilisateur - Page 29

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco EX90. Cisco EX90 49 pages. Telepresence system
Également pour Cisco EX90 : Manuel de l'utilisateur (50 pages), Manuel de référence rapide (2 pages), Manuel de l'utilisateur (37 pages), Manuel de référence rapide (2 pages), Manuel de démarrage (42 pages), Manuel de l'utilisateur (45 pages), Manuel d'installation (6 pages), Manuel de référence rapide (2 pages), Manuel de l'utilisateur (7 pages), Manuel de dépannage (37 pages), Manuel d'installation (2 pages), Manuel de l'utilisateur (45 pages), Manuel de l'utilisateur (37 pages), Manuel de démarrage (46 pages)

Cisco TelePresence System EX90

Contents

Introduction

Setting the EX90 in standby

Outside a call, you may have the unit enter standby mode by touching the

Power button on the main unit (the screen). The Standby dialog is displayed

and the unit enters standby immediately. This does not work when you are in a

call.

Shutting down the EX90

Outside a call, press the Power button until the Shutdown progress bar is filled

completely.

Release the button and the unit will go in shutdown in just a few seconds.

D14724.09

User guide EX90, TC5.1, January 2013

Connecting the EX90

Using the EX90

Tap as shown to

wake up the system

from standby.

To start the system again,

press the Power button

until the LED illuminates

(green light).

Scheduled meetings

Reverting to factory default settings

to revert to the factory default settings, do as follows:

Disconnect the power cord.

Reconnect the power cord—a green light will illuminate shortly after.

Press the Power button as soon as the green light appears. Keep it de-

pressed for 15 seconds or so, until the green light starts flashing.

Release the button and press twice within 2 seconds. All settings will now

revert to factory default settings.

User guide

The settings