Argo ULISSE ECO Manuel d'utilisation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Argo ULISSE ECO. Argo ULISSE ECO 16 pages. Room air conditioner with remote condenser
Également pour Argo ULISSE ECO : Manuel d'installation (14 pages)
Imprimer la page
USING THE REMOTE CONTROL UNIT
EN
HOW TO INSTALL BATTERIES
• Remove trhe lid in the rear part of the remote control
unit.
• Insert two AAA alkaline batteries of 1,5 V-DC making
sure that point in the direction marked in the battery
compartment.
• Set the clock (see procedure on page 8).
Remote controller is now ready for operation.
• The batteries last about six months. Depending on how
much you use the remote control unit.
Remove the batteries if you do not use the remote
control unit for more than one month.
Replace the batteries when the battery symbol appears
on the remote control (
• The batteries of the remote control contain polluted
substances. Exhausted batteries must be disposed
according to the laws in force.
HOW TO REMOVE BATTERIES
• Remove the lid.
• Press the battery
t o w a r d
t h e
n e g a t i v e
e n d
and lift it out by
its positive end
(as shown in the
figure).
• Remove the other
battery in the same
way.
TEMPERATURE SENSOR SELECTOR
• Under normal conditions the room temperature is
detected and checked by the temperature sensor placed
in the remote controller ( IFEEL
function is designed to provide a comfortable room
temperature by transmitting the temperature control
command from the location next to you. When using this
function, the remote, control should always be pointed
at the air conditioner, therefore it should be placed in
a position in which it is visible by the indoor unit (for
example, do not put it in a drawer).
It is possible to disable the remote controller room sensor
●
pressing the FAN/IFEEL
this case the icon on the remote controller display lights
off and the sensor placed in the air conditioner becomes
active.
RESET
-
+
-
+
).
icon displayed ).This
button for a few seconds. In
NOTE
The remote control unit transmits signals to the indoor
unit each time you press a key and at any temperature
change detected by the internal sensor. In case of
troubles (low batteries, remote control placed in
a position not visible by the indoor unit,...) room
temperature control is automatically switched to the
sensor of the indoor unit. In this case, the temperature
around the remote control unit may differ from the
temperature detected in the air conditioner position.
OPERATION WITH THE REMOTE CONTROL UNIT
When using the remote control unit, always point the unit
transmitter head directly at the air conditioner receiver.
INDOOR UNIT
TRANSMITTER HEAD
REMOTE
CONTROL UNIT
6
RECEIVER