Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 18 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Manuel de l'utilisateur (17 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

Installing the MSFC2

Caution

Ensure that the MSFC2 is securely seated before you install and tighten the securing screws. Using the

screws to seat the MSFC2 could warp the card.

Use a Phillips-head screwdriver to install the screws and cap nut (if applicable) that secure the MSFC2

Step 5

to the supervisor engine. (See

for an MSFC2 shipped after November 2001.)

You must install the cap nut (if applicable) and all screws. The screws provide grounding between the

Caution

MSFC2 and the supervisor engine. Failure to install the cap nut and all screws will invalidate the safety

approvals and can cause fire and electrical hazards.

Figure 11

Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note

Figure 11

MSFC2 Shipped Before November 2001—Installing the Securing Screws and Cap Nut

WS-X5530

SWITCH LOAD

100%

SUPERVISOR ENGINE I I I

CONSOLE

for an MSFC2 that shipped before November 2001, or

Figure 12

cap nut

78-14357-02