Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel de l'utilisateur

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 17 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

Imprimer la page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel de l'utilisateur
Cisco Catalyst 6500 Virtual Switching System
Deployment Best Practices
Document ID: 109547
Contents
Introduction
Prerequisites
Requirements
Components Used
When removing the preempt commands in Catalyst 6500 Series Switches in VSS Mode, will it reload the
switches?
Introduction
This document provides best practices for Cisco Catalyst 6500 Virtual Switching System (VSS) 1440
deployment scenarios.
This document provides modular configuration guidance. Therefore, you can read each section independently
and make changes in a phased approach. This document assumes a basic comprehension and familiarity with
the Cisco IOS® Software user interface. The document does not cover overall network design.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.