Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel de l'utilisateur - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 17 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Note d'installation (24 pages), Manuel (19 pages), Note d'installation (36 pages)

Imprimer la page

Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel de l'utilisateur

•

VSL cannot be configured as SPAN destination.

•

VSL cannot be configured as source of RSPAN, ERSPAN, or Tx only local SPAN.

•

VSL header is removed by SPAN destination port before packet is transmitted out, and hence cannot

be captured in the sniffer traces.

•

When the source and destination are both on the same chassis (active or standby), then SPAN traffic

does not flow over the VSL link.

In order to capture traffic from both chassis, there are two options which avoids the flow of SPAN

traffic on the VSL:

♦

For each source interface on one chassis, the destination interface must be on the same

chassis.

For example, PO20 has gi1/1/1 and gi2/1/1: you need to have one destination for each

chassis.

However, this means that you use both the local SPAN sessions. Therefore, you cannot use

any other local SPAN session.

♦

You can use the destination interface for SPAN as a MEC (recommended).

The destination port can be a MEC.

Miscellaneous

Recommendations

•

Use a minimum of one Supervisor uplink for VSL in order to have faster VSL bring up.

•

Configure the switch accept mode virtual command after VSS conversion. Without this command,

the conversion is not complete.

•

Save the backup of the configuration file in both active and hot−standy bootdisk:. This is of much

help in supervisor replacement scenarios.

•

Use unique VSS domain−ID within the same network. Duplicate VSS domain−ID can cause

EtherChannel inconsistency.

Here is an example to change the VSS domain−ID.

Use the switch virtual domain domain−id command in order to initiate the domain ID

change.

Note: Domain ID 50 config takes effect only after the switch convert mode virtual exec

command is issued.

Use the switch convert mode virtual command in order to complete the task.

Note: Virtual Domain ID changes only after you save the config and reload the switch.

Monitor session 1 source interface gi1/1/1

Monitor session 1 destination interface gi1/1/2

Monitor session 2 source interface gi2/1/1

Monitor session 2 destination interface gi2/1/2

switch(config)#switch virtual domain 50

switch#switch convert mode virtual