Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Note d'installation pour {nom_de_la_catégorie} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 pages. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Également pour Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion : Note d'installation (14 pages), Manuel de solution (17 pages), Note d'installation (46 pages), Livre blanc (19 pages), Description (1 pages), Bulletin d'information sur les produits (6 pages), Avis (4 pages), Fiche technique (9 pages), Fiche technique (18 pages), Livre blanc (18 pages), Manuel de configuration (8 pages), Note d'installation (28 pages), Manuel de dépannage (11 pages), Note d'installation (18 pages), Manuel de l'utilisateur (17 pages), Manuel (19 pages), Note d'installation (36 pages)

Imprimer la page
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Note d'installation

Environmental and System Requirements

Table 1
Color
Orange
Green
Green to orange
1. Enter the show environment temperature mod command to display the temperature of each of four sensors on the CSM.
2. CLI = command-line interface.
RJ-45 Connector
The RJ-45 connector, which is covered by a removable plate, is used to connect a management station
device or a test device. This connector is used by field engineers to perform testing and to obtain dump
information.
Environmental and System Requirements
This section describes the environmental and system requirements.
•
•
Environmental Requirements
Table 2
Table 2
Item
Temperature, ambient operating
Temperature, ambient nonoperating
Humidity (RH), ambient (noncondensing)
operating
Nonoperating relative humidity (noncondensing) 5% to 95%
Catalyst 6500 Series Switch Content Switching Module Installation Note
6
Content Switching Module Status LED (continued)
Description
The module is initializing hardware or communicating with the supervisor
•
engine.
A fault occurred during the initialization sequence.
•
The module has failed to download its Field Programmable Gate Arrays
•
(FPGAs) on power up but continues with the remainder of the initialization
sequence and provides the module online status from the supervisor engine.
•
The module has not received module online status from the supervisor engine.
This problem could be caused by the supervisor engine detecting a failure in
an external loopback test that it issued to the CSM.
•
The module is operational; the supervisor engine has provided module online
status.
•
The module is disabled through the supervisor engine CLI
module disable mod command.
Environmental Requirements, page 6
System Requirements, page 7
lists the environmental requirements for the CSM.
CSM Environmental Requirements
Specification
o
o
o
o
0
to 40
C (32
to 104
F)
o
o
o
o
–40
to 70
C (–40
to 158
10% to 90%
2
using the set
F)
78-15751-01