Cisco 7505 Manuel de démarrage rapide - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 7505. Cisco 7505 32 pages. 600w ac-input power supply and fan tray replacement
Également pour Cisco 7505 : Manuel d'instructions de remplacement (23 pages), Manuel d'instructions d'installation (15 pages), Manuel d'instructions de remplacement (18 pages)

Imprimer la page

Install Field Replaceable Units (FRUs)

Remove and Install an Interface Processor, Filler, VIP, or RSP

Captive

installation

screw

Bottom ejector lever

Card

carrier

slot

guide

STOP!

on contact

Note

Do not shut down the system power when

removing an interface processor or VIP. However, if

you are removing the RSP, ﬁrst copy the

conﬁguration ﬁle to a TFTP server (see the "Copy the

Conﬁguration File for an RSP" section on page 21),

and then return to this section to complete the

procedure.

Step 1

Attach an ESD-preventive wrist strap

between you and any unpainted chassis

surface.

Step 2

Disconnect all cables from the interface

processor, VIP, or RSP port adapters. If

you are only moving a carrier, skip this

step.

Step 3

Use a screwdriver to loosen the captive

installation screws, as shown in A.

Step 4

Place your thumbs on both ejector levers

and simultaneously pull them both

outward, as shown in B.

Step 5

Grasp the interface processor, ﬁller, VIP,

or RSP handle with one hand and pull the

carrier straight out of the slot, keeping

your other hand under the carrier to guide

it.

Step 6

Store the interface processor, VIP, or RSP

in an antistatic bag.

Step 7

Repeat Step 2 through Step 6 to remove

any additional interface processors, ﬁllers,

VIPs, or RSPs. Refer to the "Install

Interface Processors, Fillers, VIPs, and

RSPs" section on page 4 to install an

interface processor, ﬁller, VIP, or RSP.