Cisco 7505 빠른 시작 매뉴얼 - 페이지 20

{카테고리_이름} Cisco 7505에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7505 32 페이지. 600w ac-input power supply and fan tray replacement
Cisco 7505에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (23 페이지), 설치 지침 매뉴얼 (15 페이지), 교체 지침 매뉴얼 (18 페이지)

페이지 인쇄

Install Field Replaceable Units (FRUs)

Remove and Install an Interface Processor, Filler, VIP, or RSP

Captive

installation

screw

Bottom ejector lever

Card

carrier

slot

guide

STOP!

on contact

Note

Do not shut down the system power when

removing an interface processor or VIP. However, if

you are removing the RSP, ﬁrst copy the

conﬁguration ﬁle to a TFTP server (see the "Copy the

Conﬁguration File for an RSP" section on page 21),

and then return to this section to complete the

procedure.

Step 1

Attach an ESD-preventive wrist strap

between you and any unpainted chassis

surface.

Step 2

Disconnect all cables from the interface

processor, VIP, or RSP port adapters. If

you are only moving a carrier, skip this

step.

Step 3

Use a screwdriver to loosen the captive

installation screws, as shown in A.

Step 4

Place your thumbs on both ejector levers

and simultaneously pull them both

outward, as shown in B.

Step 5

Grasp the interface processor, ﬁller, VIP,

or RSP handle with one hand and pull the

carrier straight out of the slot, keeping

your other hand under the carrier to guide

it.

Step 6

Store the interface processor, VIP, or RSP

in an antistatic bag.

Step 7

Repeat Step 2 through Step 6 to remove

any additional interface processors, ﬁllers,

VIPs, or RSPs. Refer to the "Install

Interface Processors, Fillers, VIPs, and

RSPs" section on page 4 to install an

interface processor, ﬁller, VIP, or RSP.