Argo Wallner RS6600-C Manuel d'instruction - Page 14
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Argo Wallner RS6600-C. Argo Wallner RS6600-C 16 pages.
Imprimer la page
serVice
Proceed only with routine actions according to the manual. Do not repair or service machi-
nes on your own. Unplug the machine from the circuit and contact seller when one or more
of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual
PrOBlem sOlViNG
problems
No operation
No operation after
long time operation
stop at shredding
excess squeaking
and rubbing noise
Paper jam
© arGO s.a.
EN
checklists
The power plug is properly
inserted to main supply?
switch is set at „i" position?
switch at „l" position but power
light off?
Basket at stand but power light
off?
No operation while inserting
paper?
checked above, but still no
operation and no power light?
Power lamp is on?
Machine was continuously
shredding for a longer time?
Without oiling to the cutting
system periodically,
- squeaking and rubbing noise at
shredding may appear.
- exceeding the shredding
capacity
- The paper is not fed squarely
into the feed opening.
14
solutions
Fully put the power plug to the
outlet.
set switch to „i" position for
operation.
check if the basket is out of
stand. Put basket back to stand.
Take the basket out, check the
plug and put it back to place.
Paper should be inserted to
trigger the sensor at center.
send back to your local service
for repair.
Unplug the machine from
main supply. allow to cool
down to room temperature
and resuming operation.
Unplug the machine from
main supply. allow to cool
down to room temperature
and resuming operation.
Perform the cutter oiling
instruction to lubricate the
cutting system.
set switch to „reverse" for
reverse running and to free
excess paper. Then set to „i" for
cutting the remainder of paper
left in the cutting system.
if serious jam occurred, send
back to local service for repair.
www.argo.pl