Sony SA-40SE1 Manuel d'utilisation - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Sony SA-40SE1. Sony SA-40SE1 20 pages. All-in-one soundbar
Également pour Sony SA-40SE1 : Garantie limitée (1 pages), Spécifications (2 pages)

Imprimer la page

Troubleshooting

If you experience any of the following

difficulties while using the unit, use this

troubleshooting guide to help you remedy the

problem. Should any problem persist, consult

your nearest Sony dealer.

POWER

The power is not turned on.

• Make sure the AC adaptor and the AC

power cord (mains lead) is connected

correctly and firmly (page 11).

• Press the ?/1 (POWER) button on the

unit. The SOUND FIELD indicator lights

up in green.

The unit enters standby mode

automatically.

• The unit enters standby mode

automatically when there is no sound input

for approximately 5 minutes.

SOUND

There is no sound or only a very low-

level sound is heard.

• Check that the audio cord of the unit and

the TV is fully inserted (page 10).

• Press VOL 2 + (or 2 + on the unit)

repeatedly (page 7).

• Cancel the muting function of the TV.

• Check that headphones are not connected

to the TV.

Sound from the unit is not

synchronized with TV.

• For some TV models, the sound from the

unit and sound of a TV may not be

synchronized when sound is output from

both the unit and TV. Set the sound output

jack of the TV to "Fixed" if it can be

switched between "Fixed" and "Variable".

Set the TV volume to minimum or mute

the TV sound and adjust the volume of the

unit.

• If any other home theatre system is used at

the same time, turn off the power of the

unit.

The sound is distorted.

• Press TV VOL 2 – repeatedly (page 8).

• Press VOL 2 – (or 2 – on the unit)

repeatedly (page 7).

There is severe noise.

• Someone is using a portable telephone or

other equipment that emits radio waves

near the unit. Move the portable telephone,

etc. away from the unit.

REMOTE CONTROL

The remote control does not function.

• Point the remote control at the remote

control sensor on the unit (page 7).

• Remove any obstacles in the path between

the remote control and the unit.

• Replace all the batteries in the remote

control with new ones, if they are weak.