Cisco C9300-48S Manuel d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco C9300-48S. Cisco C9300-48S 16 pages.

its original factory settings.

Safety and Warnings

These operations are to be taken with respect to all local laws. Please take the following into consideration for safe

operation:

• Power off the unit before you begin. Read the installation instructions before connecting the system to the power

source.

• Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with

standard practices for preventing accidents.

• Read the mounting instructions carefully before beginning installation. Failure to use the correct hardware or to

follow the correct procedures could result in a hazardous situation to people and damage to the system.

• This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the protective

device is rated not greater than: 15 A, 125 Vac, or 10A, 240 Vac.

• Please only power the device with the provided power cables to ensure regulatory compliance.

Catalyst 9300-M Deployment Best Practices

Before powering on devices or connecting an uplink port to the LAN, ensure to follow the steps outlined below or

watch this

short

video.

Configure your Dashboard Network

To add devices to your Meraki dashboard network please refer to the

document.

Check and Set Network Firmware

Ensure that the switch network is set to the correct firmware version. As of Feb 2024 CS16(GA) is the recommended

version. Recommended versions are subject to change and are available in each dashboard by navigating to

Organization > Firmware Upgrades

You can refer to

Managing Firmware Upgrades

Check and Configure Upstream Firewall Settings

If a ﬁrewall is in place, it must allow outgoing connections on particular ports to particular IP addresses. The most

Creating a Dashboard Account and Organization

for steps to set network firmware to the desired version.