Cisco Catalyst 3750-E Series Manuel de démarrage - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Catalyst 3750-E Series. Cisco Catalyst 3750-E Series 27 pages. Switches and power supply modules
Également pour Cisco Catalyst 3750-E Series : Manuel de démarrage (33 pages), Bulletin d'information sur les produits (6 pages), Bulletin d'information sur les produits (5 pages), Bulletin d'information sur les produits (6 pages), Notes d'installation (20 pages)

(Optional) Enter this information in the Advanced Setting fields:

Step 17

• In the Telnet Access field, click Enable if you are going to use Telnet to manage the

switch by using the command-line interface (CLI). If you enable Telnet access, you must

enter a Telnet password.

• In the Telnet Password field, enter a password. The Telnet password can be from 1 to

25 alphanumeric characters, is case sensitive, allows embedded spaces, but does not

allow spaces at the beginning or end. In the Confirm Telnet Password field, re-enter the

Telnet password.

• In the SNMP field, click Enable to enable Simple Network Management Protocol

(SNMP). Enable SNMP only if you plan to manage switches by using CiscoWorks 2000

or another SNMP-based network-management system.

• If you enable SNMP, you must enter a community string in the SNMP Read Community

field, the SNMP Write Community field, or both. SNMP community strings

authenticate access to MIB objects. Embedded spaces are not allowed in SNMP

community strings. When you set the SNMP read community, you can access SNMP

information, but you cannot change it. When you set the SNMP write community, you

can both access and change SNMP information.

• In the System Contact and System Location fields, enter a contact name and the wiring

closet, floor, or building where the switch is located.

(Optional) You can enable IPv6 on the switch in the Advanced Settings screen. In the Enable

Step 18

IPv6 field, click Enable to enable IPv6 on the switch.

Enabling IPv6 restarts the switch when you complete Express Setup.

Note

To complete Express Setup, click Submit in the Network Settings or the Advanced Settings

Step 19

screen to save your settings. Click Cancel to clear your settings.

When you click Submit, the switch is configured and exits Express Setup mode. The PC

displays a warning message and then tries to connect with the new switch IP address. If you

configured the switch with an IP address that is in a different subnet from the PC,

connectivity between the PC and the switch is lost. If you enabled IPv6, the switch restarts.

Step 20

Disconnect the switch from the PC, and install the switch in your production network. See

the "Managing the Switch" section on page 9 for information about configuring and

managing the switch.

If you need to rerun Express Setup, see the "Resetting the Switch" section on page 23.