Cisco Catalyst 7500 Series Manuel de dépannage - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de dépannage pour {nom_de_la_catégorie} Cisco Catalyst 7500 Series. Cisco Catalyst 7500 Series 11 pages. Chassis interface board
Également pour Cisco Catalyst 7500 Series : Fiche technique (11 pages), Manuel de configuration (50 pages), Remplacement du manuel (40 pages)
Imprimer la page
MWAM System Error Messages
Maximum Buffer Allocation for Complex 0 CPUs
When upgrading processor complex images, it may be necessary to set the maximum allowable small
buffer allocation for processor complex 0 to 7000 and the maximum allowable middle sized buffer
allocation to 3500.
MWAM System Error Messages
Error messages may be received and reported in the system log (SysLog). This section lists these
messages from the MWAM SysLog Files.
Processor Complex Resetting
When upgrading MWAM software, you may see an error message similar to the following:
%SVCLC-SP-5-STRRECVD: mod 5: MWAM: No response from IOS complex <complex>, resetting
complex.
If this occurs, you must upgrade the ROMMON image (see the
section on page
After receiving the error message, proceed immediately to the procedure named
Note
ROMMON Image, page 5-11
immediately, the processor complex continues to reset at three minute intervals until the ROMMON
image upgrade process is completed. The ROMMON image upgrade process should take approximately
30 seconds to complete.
Crashinfo/Crashdump
Error Message %MWAM_FILESYSTEM-3-FC_CANNOT_FORMAT: Insufficient memory to format
bootflash file system.
Error Message %MWAM_FILESYSTEM-3-FC_FLASH_WRITE_ERROR: Cannot write to bootflash
file system:
Multiprocessor WAN Application Module User Guide
B-6
5-11.
before the error occurs again. If you are unable to perform this procedure
Explanation
The router does not have enough working storage available in heap memory to format a
file system for crashinfo data. The router will function normally without a bootflash file system,
however, the router cannot save information for problem analysis if it crashes.
Recommended Action
Try to format the file system again at a later time or shortly after a re-boot.
Explanation
The router cannot write to the bootflash.
If the problem occurred while executing a CLI command, try the command
Recommended Action
again. If problems persist, contact Cisco technical support.
Appendix B
Troubleshooting
"Upgrading the ROMMON Image"
Upgrading the
OL-7469-04