Cisco Firepower 2110 Manuel du logiciel - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel du logiciel pour {nom_de_la_catégorie} Cisco Firepower 2110. Cisco Firepower 2110 37 pages. Rack-mount and ground the chassis
Également pour Cisco Firepower 2110 : Manuel (12 pages), Manuel de déploiement (8 pages), Pour commencer (42 pages)

Imprimer la page

Reimage from Firepower Threat Defense to ASA

IMAGE=asalatest-lfbff-k8.SPA

CONFIG=

LINKTIMEOUT=20

PKTTIMEOUT=4

RETRY=20

rommon 8 > sync

Updating NVRAM Parameters...

rommon 9 > tftpdnld

Example:

Ping to troubleshoot connectivity to the server:

rommon 1 > ping 10.123.123.2

Sending 10, 32-byte ICMP Echoes to 10.123.123.2 timeout is 4 seconds

!!!!!!!!!!

Success rate is 100 percent (10/10)

rommon 2 >

Step 8

Configure network settings and prepare the disks.

When the ASA first boots up, it does not have any configuration on it. you can either follow the interactive

prompts to configure the Management interface for ASDM access, or you can paste a saved configuration or,

if you do not have a saved configuration, the recommended configuration (below).

If you do not have a saved configuration, we suggest pasting the recommended configuration if you are

planning to use the ASA FirePOWER module. The ASA FirePOWER module is managed on the Management

interface and needs to reach the internet for updates. The simple, recommended network deployment includes

an inside switch that lets you connect Management (for FirePOWER management only), an inside interface

(for ASA management and inside traffic), and your management PC to the same inside network. See the quick

start guide for more information about the network deployment:

•

http://www.cisco.com/go/asa5506x-quick

•

http://www.cisco.com/go/asa5508x-quick

•

http://www.cisco.com/go/asa5500x-quick

a) At the ASA console prompt, you are prompted to provide some configuration for the Management interface.

Pre-configure Firewall now through interactive prompts [yes]?

If you want to paste a configuration or create the recommended configuration for a simple network

deployment, then enter no and continue with the procedure.

If you want to configure the Management interface so you can connect to ASDM, enter yes, and follow

the prompts.

b) At the console prompt, access privileged EXEC mode.

enable

The following prompt appears:

Password:

Cisco ASA and Firepower Threat Defense Reimage Guide