Digitrax SDN144K1E Manuel de l'utilisateur - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Digitrax SDN144K1E. Digitrax SDN144K1E 12 pages. N scale drop in decoder with soundfx 1 amp/1.25 amp peak, 4 fx3 200ma functions, includes 13mm 8 ohm round speaker
Imprimer la page
Parts List
1 SDN144K1E Decoder drop-in with Sound FX™
1 Factory wired 13mm round 8 Ohm speaker.
1 330 uF capacitor (For Optional Install),
Installation Information
See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions. . Machining or modification of frames requires some skill and
patience, as they are easily damaged. After market pre-machined frames may
be available for some locomotives.
Figure 1: SDN144K1E installation in Kato N- SD40-2 frame preparation.
N scale SD40-2 shell
track pickup springs
13mm
Factory
speaker
1. Carefully remove the Kato sd40-2 shell parts. Remove the factory analog
light PCB, trucks, drive shafts, motor and all parts and carefully save these
in the correct order for re-installation. This should leave a bare frame ready
to be modified to accommodate the speaker.
2. The factory 13mm speaker is mounted in the diesel tank in this installation
example in Figure 1. Carefully open an e.g. 1/2" hole 0.150" deep through
the diesel tank area of the bare frame as shown in Figure 2. If using a drill
or mill, be sure to clamp the frames correctly. With a dremel grinder etc.,
open up the full e.g. 0.150" depth of the hole diameter so that the 13mm
speaker will fit snugly and clear the diesel tank cover. Using a grinding or
©2010 Digitrax, Inc.
Complete Train Control
Run Your Trains, Not Your Track!
www.digitrax.com
1 Instruction sheet
Kato SD40-2 frame
motor saddle area
SDN144K1E
2