Digitrax SDN144K1E Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа Digitrax SDN144K1E. Digitrax SDN144K1E 12 сторінок. N scale drop in decoder with soundfx 1 amp/1.25 amp peak, 4 fx3 200ma functions, includes 13mm 8 ohm round speaker

Друкувати сторінку

Parts List

1 SDN144K1E Decoder drop-in with Sound FX™

1 Factory wired 13mm round 8 Ohm speaker.

1 330 uF capacitor (For Optional Install),

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. . Machining or modification of frames requires some skill and

patience, as they are easily damaged. After market pre-machined frames may

be available for some locomotives.

Figure 1: SDN144K1E installation in Kato N- SD40-2 frame preparation.

N scale SD40-2 shell

track pickup springs

13mm

Factory

speaker

1. Carefully remove the Kato sd40-2 shell parts. Remove the factory analog

light PCB, trucks, drive shafts, motor and all parts and carefully save these

in the correct order for re-installation. This should leave a bare frame ready

to be modified to accommodate the speaker.

2. The factory 13mm speaker is mounted in the diesel tank in this installation

example in Figure 1. Carefully open an e.g. 1/2" hole 0.150" deep through

the diesel tank area of the bare frame as shown in Figure 2. If using a drill

or mill, be sure to clamp the frames correctly. With a dremel grinder etc.,

open up the full e.g. 0.150" depth of the hole diameter so that the 13mm

speaker will fit snugly and clear the diesel tank cover. Using a grinding or

Complete Train Control

Run Your Trains, Not Your Track!

www.digitrax.com

1 Instruction sheet

Kato SD40-2 frame

motor saddle area

SDN144K1E