Digitrax SoundFX SDXN146K2 Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Digitrax SoundFX SDXN146K2. Digitrax SoundFX SDXN146K2 12 pages.

Figure 2: SDXN146K2: Completed installation without locomotive shell

Replace the locomotive shell.

Place the loco on an active DCC track powered by a compatible DCC system

and select the factory default address 03 to enable sounds for testing.

Be sure F8 (mute) is OFF to allow sound output, and then press

F1 (bell) or F2 (whistle/horn) ON to hear the associated sounds.

Customize sounds by programming Sound CVs to adjust the desired config-

urations, as shown in the following tables of SoundFX CVs. Sound schemes

other than the 8 factory preloaded can be loaded by using a Digitrax PR3

SoundFX Programmer

Note: This is a example installation for this Locomotive, other installs

may require modification of the locomotive to make space for the speaker

and capacitor.

Customizing Your Decoder

Your Digitrax SDXN146K2 SoundFX decoder is ready to run and will

operate and generate sound using address 03 with no additional

programming. On your Digitrax system, simply select the locomotive's

address and the sound will start. On some DCC systems, it is necessary to

select the locomotive address AND send a command to start the sounds.

For a more prototypical railroading experience, your decoder can be

customized for your specific locomotive by programming some of the

Configuration Variables, or CVs, available. Before customizing the de-

coder it is useful to run it on the factory default address 03 to check the

installation. Digitrax Sound decoders can be programmed using either

a programming track or with the operations mode using the main line.

The following sections show how to change the locomotive address and

customize the decoder. See the Digitrax Decoder Manual or the Digitrax

web site for more information.

CAUTION: Programming track must not exceed 16V when

programming this decoder.

100uF Capacitor

— 3 —

8 Ohm 10 mm x 18 mm Oval

Speaker