Digitrax DN166I2 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Digitrax DN166I2. Digitrax DN166I2 8 pages. Complete train control
Imprimer la page
Parts List
1 DN166I2 Mobile Decoder
Installation Information
See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions. CAUTION: Programming and layout track must not exceed
16V when using this decoder.
Installation Instructions
1.
Carefully remove the locomo-
tive's shell from the frame by
inserting two toothpicks under
the unit's ladders as shown.
2.
Once you've positioned the
toothpicks, grasp the frame and
toothpicks with one hand and
the locomotive's shell with the
other hand and carefully sepa-
rate the two.
3.
Once the shell is off, remove the
existing light board by removing
the two screws located on the
diagonal corners of the board.
The final step in removing the
light board is to carefully unsol-
der the two wires leading from
the headlight assembly.
4.
Take the new DN166I2 decoder
and place it on top of the frame.
Note proper orientation. The
decoder's brass motor contacts
should fit in the frame slot as
shown.
5.
Solder headlight leads to the
new decoder board as shown If
you were sitting in the cab,
the yellow lead would be on
your left and the green lead
would be on your right. The
final step is to secure the decod-
© 2014 Digitrax, Inc.
Toothpicks
inserted under
the steps
Figure 1: Insert toothpicks
as shown
Figure 2: Grasp toothpicks and gently
remove shell from frame.
Figure 3: Unscrew, unsolder and remove
standard lightboard.
— 2 —
1 Instruction Sheet
Decoder's brass contacts
should engage motor
contacts fully and NOT
contact frame.
www.digitrax.com