Digitrax DN166I2 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Digitrax DN166I2. Digitrax DN166I2 8 pagina's. Complete train control

Pagina afdrukken

Parts List

1 DN166I2 Mobile Decoder

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Installation Instructions

Carefully remove the locomo-

tive's shell from the frame by

inserting two toothpicks under

the unit's ladders as shown.

Once you've positioned the

toothpicks, grasp the frame and

toothpicks with one hand and

the locomotive's shell with the

other hand and carefully sepa-

rate the two.

Once the shell is off, remove the

existing light board by removing

the two screws located on the

diagonal corners of the board.

The final step in removing the

light board is to carefully unsol-

der the two wires leading from

the headlight assembly.

Take the new DN166I2 decoder

and place it on top of the frame.

Note proper orientation. The

decoder's brass motor contacts

should fit in the frame slot as

shown.

Solder headlight leads to the

new decoder board as shown If

you were sitting in the cab,

the yellow lead would be on

your left and the green lead

would be on your right. The

final step is to secure the decod-

Toothpicks

inserted under

the steps

Figure 1: Insert toothpicks

as shown

Figure 2: Grasp toothpicks and gently

remove shell from frame.

Figure 3: Unscrew, unsolder and remove

standard lightboard.

— 2 —

1 Instruction Sheet

Decoder's brass contacts

should engage motor

contacts fully and NOT

contact frame.