Cisco Physical Access 1125 Appliance Manuel de l'utilisateur - Page 20
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco Physical Access 1125 Appliance. Cisco Physical Access 1125 Appliance 42 pages.
Imprimer la page
Rack Mounting the Cisco PAM 1125 Appliance
Rack Mounting the Cisco PAM 1125 Appliance
This chapter provides procedures for installing rail hardware on the Cisco PAM appliance and mounting
the appliance on a two-post or four-post rack.
This chapter contains the following sections:
•
•
•
•
You will need to have the following items to complete the rack mounting procedure:
•
•
The fastener pack, within the rail installation kit, contains eight rack screws, but you must check these
Caution
to ensure that they are the appropriate size for the holes in your rack. Using the wrong size screws for
your threaded rack holes can damage the rack.
Installation Precautions
Before you begin the installation, review the warnings and cautions in this section.
Warning
APPLIANCE POWER ON/OFF: The push-button on/off power switch on the front panel of the appliance
does not turn off the AC power. To remove AC power from the appliance, you must unplug the AC
power cord from either the power supply or wall outlet.
HAZARDOUS CONDITIONS—POWER SUPPLY: Hazardous voltage, current, and energy levels are
Warning
present inside the power supply enclosure. There are no user-serviceable parts inside it; servicing
should only be done by technically qualified personnel.
HAZARDOUS CONDITIONS—DEVICES AND CABLES: Hazardous electrical conditions may be present
Warning
on power, telephone, and communication cables. Turn off the appliance and disconnect
telecommunications systems, networks, modems, and the power cord attached to the appliance
before opening it. Otherwise, personal injury or equipment damage can result.
AVOID INJURY: Lifting the appliance chassis and attaching it to the rack is a two-person job. A fully
Warning
loaded Cisco PAM appliance can exceed 13.9 kg (30.6 lbs.). If needed, use an appropriate lifting
device.
Cisco Physical Access 1125 Appliance User Guide
3-2
Installation Precautions, page 3-2
Contents of the Rail Installation Kit, page 3-3
Mid-Mounting the 1125 Appliance on a Two-Post Rack, page 3-4
Front-Mounting the 1125 Appliance on a Two-Post Rack, page 3-9
A cross (Phillips) screwdriver
Four (4) rack screws
Chapter 3
Rack Mounting the Cisco PAM 1125 Appliance
OL-20929-01