Cisco PIX 506E Manuel de démarrage rapide - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco PIX 506E. Cisco PIX 506E 17 pages. Chapter 3
Également pour Cisco PIX 506E : Manuel de démarrage rapide (18 pages), Manuel de l'utilisateur (8 pages)
Imprimer la page
Alternative Ways to Access the PIX 506E
You can access the command-line interface (CLI) for administration using the console port on the PIX
Firewall. To do so, you must run a serial terminal emulator on a PC or workstation.
AC T
LI NK
ET HE RN
ET 1
PC terminal adapter
To connect a console for local administrative access:
Plug one end of the console cable adapter into a standard 9-pin PC serial port.
Step 1
Plug one end of the blue console cable (72-1259-01) into the PC terminal adapter.
Step 2
Plug the other end of the blue console cable into the Console port.
Step 3
Step 4
Configure the PC terminal emulation software or terminal for 9600 baud, 8 data bits, no
parity, and 1 stop bit.
You can also access the CLI using SSH/Telnet to the PIX Firewall. By default, SSH/Telnet access is not
permitted. Use PDM or the console to configure SSH/Telnet access to the PIX Firewall. To Telnet to
the PIX Firewall from the outside perimeter of the firewall, configure an outside IP address and IPSec
for a secure Telnet session. Refer to the Cisco PIX Firewall and VPN Configuration Guide for more
information about how to use the command-line interface (CLI).
10
DC
AC T
PO W ER
LI NK
DC
IN PU T
ET HE RN
PO W ER
ET 0
IN PU T
US B
CO NS O LE
Cisco PIX 506E
Blue console cable