Cisco Prisma EtherLinX Manuel d'instructions d'installation - Page 23
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 pages.
Imprimer la page
SNMP Management,
Follow these steps to connect the Prisma EtherLinX unit to your terminal/computer.
1.
Plug one end of the cable into the DB-9 connector on the Prisma EtherLinX
unit.
2.
Plug the other into the appropriate port on your computer/terminal.
3.
Set your computer/terminal for VT-100 emulation.
The serial port on the computer/terminal should be set for: 38.4K baud, 8 data bits, 1
stop bit, no parity and no flow control.
Main Configuration Screen
After running through an initial self test, the screen displays the following message:
Press <Enter> for Device Configuration. Press Enter to go to the Main
Configuration screen. Here you will find several displays:
• Saved Values — displays changes made during current session.
− IP Address (MUST be assigned during initial configuration)
− Subnet Mask (MUST be assigned during initial configuration)
− Default Gateway
− Server IP Addr (TFTP server)
− New Prom File (firmware file name)
• Current Values — displays values currently in use.
− IP Address (IP address of SNMP agent)
− Subnet Mask (mask to define IP subnet agent is connected to)
− Default Gateway (default router for IP traffic outside subnet)
− Server IP Addr (TFTP server)
− New Prom File (firmware file name)
4008226 Rev B
Continued
Continued on next page
23