Cisco Prisma EtherLinX Руководство по установке - Страница 23
Просмотреть онлайн или скачать pdf Руководство по установке для Сетевое оборудование Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 страниц.
Печатать страницу
SNMP Management,
Follow these steps to connect the Prisma EtherLinX unit to your terminal/computer.
1.
Plug one end of the cable into the DB-9 connector on the Prisma EtherLinX
unit.
2.
Plug the other into the appropriate port on your computer/terminal.
3.
Set your computer/terminal for VT-100 emulation.
The serial port on the computer/terminal should be set for: 38.4K baud, 8 data bits, 1
stop bit, no parity and no flow control.
Main Configuration Screen
After running through an initial self test, the screen displays the following message:
Press <Enter> for Device Configuration. Press Enter to go to the Main
Configuration screen. Here you will find several displays:
• Saved Values — displays changes made during current session.
− IP Address (MUST be assigned during initial configuration)
− Subnet Mask (MUST be assigned during initial configuration)
− Default Gateway
− Server IP Addr (TFTP server)
− New Prom File (firmware file name)
• Current Values — displays values currently in use.
− IP Address (IP address of SNMP agent)
− Subnet Mask (mask to define IP subnet agent is connected to)
− Default Gateway (default router for IP traffic outside subnet)
− Server IP Addr (TFTP server)
− New Prom File (firmware file name)
4008226 Rev B
Continued
Continued on next page
23