Cisco 7513 Series Manuel d'instructions de remplacement - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de remplacement pour {nom_de_la_catégorie} Cisco 7513 Series. Cisco 7513 Series 22 pages. Chassis replacement
Également pour Cisco 7513 Series : Manuel de démarrage rapide (44 pages), Manuel d'instructions de remplacement (26 pages), Fiche technique (11 pages), Manuel (30 pages), Maintien (20 pages), Manuel d'instructions de remplacement (19 pages)

Imprimer la page
Cisco 7513 Series Manuel d'instructions de remplacement
Replacing the Chassis
Following is an example of the show controller cbus command display. (In this example, ROM
Version 1.0 is assumed because you cannot determine the ROM version with screen displays unless
it is the running version.)
The command show interfaces serial slot/port displays statistics for the specific serial interface you
specify by its slot/port address. If you use this command without the type and slot/port arguments,
the system will display statistics for all interfaces in the system.
The command show configuration displays the contents of the system configuration file stored in
NVRAM.
The command show protocols displays the global (system-wide) and interface-specific status of any
configured Level 3 protocol.
20 Cisco 7513 Chassis Replacement Instructions
Router# show controllers cbus
(text omitted from example)
FSIP 1, hardware version 1.0, microcode version 1.0
Interface 8 - Serial1/0, electrical interface is V.35 DTE
(text omitted from example)
Interface 9 - Serial1/1, electrical interface is V.35 DTE
(remainder of displayed text omitted from example)
Router> show int hssi 1/0
Hssi 1/0 is up, line protocol is up
Hardware is cxBus HIP
Internet address is 1.1.1.9, subnet mask is 255.255.255.0
(display text omitted)
Router# show config
Using 1652 out of 130048 bytes
version 10.3(571)
!
hostname Router
!
enable-password guessagain
!
microcode TRIP flash trip1-0
microcode reload
!
interface hssi1/0
ip address 1.1.1.67
ip route-cache cbus
no keepalive
!
interface serial2/1
ip address 1.1.1.12
(display text omitted)
Router> show protocols
Global values:
Internet Protocol routing is enabled
Hssi1/0 is up, line protocol is up
(display text omitted)