Cisco ONS 15454 Manuel d'instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Cisco ONS 15454. Cisco ONS 15454 22 pages. Four-shelf and zero-shelf bay assembly
Également pour Cisco ONS 15454 : Installer (32 pages), Installer (32 pages), Déballage et installation (42 pages), Déballage et installation (40 pages)
Imprimer la page
NTP- A15 Install the Common Control Cards
NTP-A15 Install the Common Control Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid electrostatic discharge (ESD) damage to
Warning
the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock
yourself. Statement 94
Caution
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Caution
installing the cards.
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
If you plan to install XCVT cards, review
Step 1
install XC10G or XC-VXC-10G cards, review
compatibility.
Complete the
Step 2
Complete the
Step 3
Complete the
Step 4
as needed.
Note
Install the traffic cards. To determine the appropriate procedure for a particular card, see the NTP list in
Step 5
the
In
Table
and 12 to 17, include four slots (Slots 5, 6, 12, and 13) that have four times the bandwidth of the other
multiservice slots.
Cisco ONS 15454 Procedure Guide, R8.0
2-2
This procedure describes how to install the common control cards.
Redundant TCC2/TCC2P cards
Redundant XCVT, XC10G, or XC-VXC-10G (cross-connect) cards
AIC-I card (optional)
NTP-A13 Perform the Shelf Installation Acceptance Test, page 1-30
Required
Onsite
Provisioning or higher
"DLP-A36 Install the TCC2/TCC2P Cards" task on page
"DLP-A37 Install the XCVT, XC10G, or XC-VXC-10G Cards" task on page
"DLP-A41 Install the Alarm Interface Controller–International Card" task on page
If you install the wrong card in a slot, see the
procedure on page
2-20.
"Before You Begin" section on page
2-1, X indicates that a card is supported in the slot. The multiservice (traffic) slots, Slots 1 to 6
Chapter 2 Install Cards and Fiber-Optic Cable
Table 2-1
to determine card/slot compatibility. If you plan to
Table 2-2 on page 2-5
"NTP-A116 Remove and Replace a Card"
2-1.
to determine card/slot
17-38.
17-41.
78-17697-01
17-43,