- ページ 2

サーバー Cisco ONS 15454のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。Cisco ONS 15454 22 ページ。 Four-shelf and zero-shelf bay assembly
Cisco ONS 15454 にも：インストール (32 ページ), インストール (32 ページ), 開梱と設置 (42 ページ), 開梱と設置 (40 ページ)

ページを印刷する

NTP- A15 Install the Common Control Cards

NTP-A15 Install the Common Control Cards

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

During this procedure, wear grounding wrist straps to avoid electrostatic discharge (ESD) damage to

Warning

the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock

yourself. Statement 94

Caution

Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband

cable into the ESD jack located on the lower-right outside edge of the shelf assembly.

If protective clips are installed on the backplane connectors of the cards, remove the clips before

Caution

installing the cards.

If you install a card incorrectly, the FAIL LED flashes continuously.

Note

If you plan to install XCVT cards, review

Step 1

install XC10G or XC-VXC-10G cards, review

compatibility.

Complete the

Step 2

Complete the

Step 3

Complete the

Step 4

as needed.

Note

Install the traffic cards. To determine the appropriate procedure for a particular card, see the NTP list in

Step 5

the

Table

and 12 to 17, include four slots (Slots 5, 6, 12, and 13) that have four times the bandwidth of the other

multiservice slots.

Cisco ONS 15454 Procedure Guide, R8.0

2-2

This procedure describes how to install the common control cards.

Redundant TCC2/TCC2P cards

Redundant XCVT, XC10G, or XC-VXC-10G (cross-connect) cards

AIC-I card (optional)

NTP-A13 Perform the Shelf Installation Acceptance Test, page 1-30

Required

Onsite

Provisioning or higher

"DLP-A36 Install the TCC2/TCC2P Cards" task on page

"DLP-A37 Install the XCVT, XC10G, or XC-VXC-10G Cards" task on page

"DLP-A41 Install the Alarm Interface Controller–International Card" task on page

If you install the wrong card in a slot, see the

procedure on page

2-20.

"Before You Begin" section on page

2-1, X indicates that a card is supported in the slot. The multiservice (traffic) slots, Slots 1 to 6

Chapter 2 Install Cards and Fiber-Optic Cable

Table 2-1

to determine card/slot compatibility. If you plan to

Table 2-2 on page 2-5

"NTP-A116 Remove and Replace a Card"

2-1.

to determine card/slot

17-38.

17-41.

78-17697-01

17-43,