Cisco SCE8000 GBE Manuel de configuration - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco SCE8000 GBE. Cisco SCE8000 GBE 18 pages. 10gbe platform
Également pour Cisco SCE8000 GBE : Manuel de démarrage rapide (25 pages), Procédures de retrait et de remplacement (36 pages), Installation (21 pages)

Introduction to SIPs and SPAs

Shared Port Adapters

The SPA supported by the Cisco SCE8000-SIP is the 1-Port 10-Gigabit Ethernet SPA,

SPA-1X10GE-L-V2

The following list describes some of the general characteristics of a SPA:

•

Figure 2-4

Single-height SPA

•

The SPAs implement 10GBE small form-factor pluggable (XFP) optical transceivers to provide network

connectivity

provide network connectivity.

It is highly recommended only to use the XFP modules listed as supported in this document. Use of

Note

unsupported or unqualified XFP modules may affect reliability or operation.

Cisco SCE8000 10GBE Installation and Configuration Guide

2-6

A SPA is a modular type of port adapter that inserts into a subslot of a compatible SIP carrier card

to provide network connectivity and increased interface port density. The Cisco SCE8000-SIP can

hold up to four SPAs.

Since the interfaces are connected in subscriber/network pairs, either two or four SPAs must be

installed.

The supported SPA is a single-height SPAs, which inserts into one SIP subslot. (See

Single-Height SPA Size

Front of the SCE8000-SIP

Single-height SPA

Each SPA provides a one 10GBE port, which is the interface to either subscriber or network traffic.

These interfaces can be individually configured using the Cisco command-line interface (CLI).

Either a blank filler plate or a functional SPA should reside in every subslot of an SIP during normal

operation to maintain cooling integrity. Blank filler plates are available in single-height form only.

Since the interfaces are connected in subscriber/network pairs, the SCE8000-SIP must be either

fully populated or have both the bottom bays covered with blank filler plates.

(Figure

2-5). An XFP module is a transceiver device that mounts into the front panel to

Chapter 2

Introduction to the Cisco SCE8000 10GBE Platform

Figure

2-4.)

OL-16478-05