Cisco UCS 5100 Manuel de configuration

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco UCS 5100. Cisco UCS 5100 6 pages. Uplink ethernet connection
Également pour Cisco UCS 5100 : Mise en place (4 pages), Mise en place (17 pages), Manuel du micrologiciel (10 pages), Configuration (5 pages), Manuel (14 pages), Instructions de mise à niveau (10 pages), Manuel de démarrage rapide (8 pages)

Imprimer la page
Cisco UCS 5100 Manuel de configuration
UCS Uplink Ethernet Connection Configuration
Example
Document ID: 110267
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configure
Network Diagram
1. Configure Uplink Ethernet Ports
2. Unconfigure an Uplink Ethernet Port
Verify
Troubleshoot
Related Information
Introduction
Each Cisco Unified Computing System (UCS) provides ports that can be configured as either Server Ports or
Uplink Ports. Ports are not reserved for specific use. They must be configured. You can add expansion
modules to increase the number of Uplink Ports on the Fabric Interconnect.
Create LAN and SAN Pin Groups in order to pin traffic from servers to a specific Uplink Port.
Prerequisites
Requirements
Cisco recommends that you have a working knowledge of UCS software and hardware before you attempt
this task.
Components Used
The information in this document is based on Cisco UCS.
The information in this document was created from devices in a specific lab environment. All of the devices
used in this document started with a default configuration. If your network is live, make sure that you
understand the potential impact of any command.
Conventions
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
Configure
Cisco UCS Fabric Interconnects provide these port types: